Canadian TV, Computing and Home Theatre Forums banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
451 Posts
Discussion Starter #1
Hey All,

I recently built a house and ran three drops to every single room in the house (coax and cat6.) My question is this: with two bell receivers, how do I split the signal so that I can put 3 rooms on one receiver and 3 rooms on another? I tried splitting the signal in the basement, where the master panel is, but I didn't get a picture. Do I need to take the signal from the receiver and send it downstairs and then from there send it out? If so, how can I do this with a 6131 receiver? Any help is much appreciated!
 

·
Member #1
Joined
·
47,683 Posts
1 - 2 of 2 Posts
Status
Not open for further replies.
Top