Canadian TV, Computing and Home Theatre Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I have my new 50hdx82 hooked up to my Sony prologic receiver. When I have the audio out hooked into the stereo all (5) speakers sound good, but I end up having to use the volume control on the stereo. I hooked up the variable audio out today so I could set the stereo at a constant and use the TV volume. Doing this at low volume levels I end up with a low level "hiss" out of the rear speakers. Any ideas?

One other problem, I hooked the antenna out on the tv up to my vcr and get a bad picture. The cable works fine with a splitter on it, one to TV and one to VCR. I was trying to eliminate the splitter to get the best possible picture on the TV. Shouldn't this work?

Thanks
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #3 ·
Thanks, I'll hook it back up to the fixed output. The only complaint I have with the TV is I don't like the speakers in the TV, even for just normal TV watching. I have been leaving the stero on full time.

I thought the manual showed the output tied to a cable converter, but I might be wrong.


Thx again
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top