Canadian TV, Computing and Home Theatre Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
HI there I have a new 9241 that bell installed and i have a 6100 and two 4100 now the problem is that i only have one dish and bell disconnected a dish to get two lines to the 9241. What can i do to have all of my receivers working without adding a dish outside i could run wire as the tv that is disconnected is in the garage also known as the dog house which i tend to spend a lot of time there.

Thanks

Marc
 

·
Registered
Joined
·
510 Posts
What type of switches do you have and where are they mounted?

If you have a SW44, you should have 4 outputs from it. 2 will go to the 9241, 1 to the 6100 and 1 to the 4100.
 

·
Registered
Joined
·
10,007 Posts
Sounds like you have 5 Tuners so you will need another feed for the second 4100.

Cheapest way is to get a 4 Way Multiswitch, take the 2 lines from the 91 LNBF , that are attached to the SW44 and feed them into this 4 Way Switch, then use 2 of the outputs and connect them back to the SW44, where you took the 2, 91 degree feeds from.

The 4 Way switch now has 2 spare ports, 1 for your 4100 and a spare.

If you want or need 91 & 82 signals to the 4100, follow this link;
http://www.digitalhome.ca/forum/showthread.php?t=79134
 
1 - 3 of 3 Posts
Top