[berbs]

Here is my issue.

I have two Sony KDL-46V5100 Sets side by side in my basement each with their own Bell 6131 for separate programming.

I can't seem to set up the Harmony so that it isolates each TV and each receiver. I have separate activities set up but upon start up it still starts both TVs at the same time and only allows me to run one receiver.

Is there a way it can learn each TV and each receiver separately?

Any info would be greatly appreciated.

Thanks.

 

[57]

Well, with the BTV STBs you can set different IR codes (per the operating manual and then programme the Harmony accordingly), however, for the Sony TVs, you may be out of luck unless they also allow for different codes - check the operating manual or browse the setup menu.


Here's the thread if you can't change codes:

http://www.digitalhome.ca/forum/showthread.php?t=48693

 

[berbs]

Thanks...I can get by with the TVs the receivers are the big issue for me at this point.

 

[Nuje]

Yeah - the setting you're looking for with the BellTV boxes is "changing remote address". I think you can set any the remote address at any number from 1 to 15.

I have a 9200 and 9242 living together in perfect harmony feeding the main HDTV in the house. One's on remote address 1 and the other at #4, I think.

 

[jlet]

... and on the Harmony side, the feature you're looking for is "Confirm infrared commands" (under Device > Settings).