Canadian TV, Computing and Home Theatre Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
299 Posts
Discussion Starter · #1 ·
Hi there,

I can't seem to find out how to set a static IP for my computers with the ActionTec router installed as part of the FibreOp package.

Does anyone with this router know how to do this?

Thanks!!!
 

· Registered
Joined
·
299 Posts
Discussion Starter · #10 ·
I'm having the same problem as well. Every time I activate the Advanced DMZ and set it to my airport extreme router, I'll loose my internet connection after a few seconds. But when I refresh one of the Actiontec config pages, the internet connection comes back (for a few seconds) and then disappears again. This repeats over and over again. The funny thing is, my father has the same setup and configured the same way and his works with no problems at all.

Very confused??
Why are you using the DMZ? Is it just so you can use your Airport Extreme? Why not plug the Extreme into one of the LAN ports on the Actiontec?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top