Canadian TV, Computing and Home Theatre Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
I've done this mod. The rivets that hold the balun to the harness are centered, but that's not the only part of the balun that's making contact. When you drill out the rivets and use the spacers, only the nuts and bolts holding the balun will make contact with the harness, in the centre position.
 

·
Registered
Joined
·
24 Posts
I believe rabbit said the effective electrical connection is point B in post #221, which is off center.

But you are sayingwhen bumping out the balun, to place the bolt & spacer connection in the same hole where the rivet was (point A in post #221)


also, did you mod help

thank you
Yes, the connection is at point A. I don't know if this part of the mod makes any difference, but I'm happy with the results. At the very least flip the balun, that's an easy mod.
 
1 - 2 of 2 Posts
Top