Canadian TV, Computing and Home Theatre Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,328 Posts
The new firmware for the 605/630's have nothing to do with the older receivers. The 505's have not had any recent updates. I use some of the 550 remotes without any audio issues.
From your description, the remotes continue to control the functions of the receivers but not the TVs. Have you checked the batteries and have you reentered the TV codes as per step #5 in the programming instruction guide? The enter/OK plus the mute are held until the mode buttons flash and then the TV code is entered.
Perhaps it might do well for you to outline here the detailed steps you have tried in case further suggestions are forthcoming
 

·
Registered
Joined
·
2,328 Posts
If the TV codes are set correctly, then when you press TV plus power or channel change etc, the remote should make those changes to the TV, not just volume. You can also follow step 9 to get the remote to give you the code number read-back

Are you sure the remotes didn't get switch around? They all look the same, you might be using the wrong remote per TV?
 
1 - 2 of 2 Posts
Top