I've hooked up my DPP44, following the installation guide, but my 9242 only finds one Sat. I'll give the details of my installation and if anyone can offer any advice, it would be much appreciated. I have a Bell dish with a DPP LNBF (Bell installed). I attached the cable from the dish into the DPP44 Sat input No.1. I attached the power inserter to Receiver input 1, then a cable from the power inserter into the DPP separator, then 2 cables into the 2 inputs in the 9242. (The 9242 works fine before I put the DPP44 into the mix). I have a FTA receiver connected to Receiver input No.2. (I had unplugged the power on all receivers and the power inserter before making any connections). I then powered up the power inserter, then the 2 receivers. I then ran the check switch routine on the 9242, but the 9242 does not change the name of the switch to the DPP44 as it says it should in the manual. After this procedure, the 9242 receives all channels on Sat 91 but nothing from Sat 82. The FTA receiver gets all channels from 91. Why does the check switch routine not find the DPP44 and not see Sat 82? Please help.