Shaw Direct Satellite Signal and Dish Alignment questions - Page 31 - Canadian TV, Computing and Home Theatre Forums

Matersalad · 2013-05-09, 07:25 PM

Hello again,
Went out and bought a new 60E dish and xku lnb, aligned dish on ch 252 getting 97 percent but not getting signals for other channels?

ch299 no signal strength

Danny001 · 2013-05-09, 08:20 PM

you need the XKU signal sent to your receiver, it's called a V CODE, call shaw tell them you upgraded to the new LNB and they will take care of it. Good luck

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

2013-05-09, 07:25 PM	#451
Matersalad Rookie Join Date: Apr 2013 Posts: 8	Hello again, Went out and bought a new 60E dish and xku lnb, aligned dish on ch 252 getting 97 percent but not getting signals for other channels? ch299 no signal strength

2013-05-09, 08:20 PM	#452
Danny001 Join Date: Jun 2010 Posts: 334	you need the XKU signal sent to your receiver, it's called a V CODE, call shaw tell them you upgraded to the new LNB and they will take care of it. Good luck