dct6200/1000 stuck e609

[claynelson]

have a stb that is stuck doing the DL and E609. any idea what ic or ic's are being flashed. thanks

[spitoon]

Check out this thread --->http://www.digitalhome.ca/forum/showthread.php?t=23573

EDIT: I think your "6" may be a "b"?

[claynelson]

some info from my internet travels

Here for your enjoyment is a list of the boot error codes. Format is CODE DESCRIPTION, WHEN IT DISPLAYS, WHAT TO DO.

The codes. (from a '5100 install manual)

Eb 01 Object failed validation After the LED displays dl, indicating validation check failed, Contact headend operator

Eb 02 Download time-out After cycling twice through the OOB frequencies, None

Eb 03 Flash erase failed After software object download complete and EF is displayed, Replace DCT5100

Eb 04 Flash programming failed, After software object download complete and FP is displayed, Contact headend operator

Eb 05 Invalid DLC frequency, After the LED displays dl indicating validation check failed, Contact headend operator

Eb 06 Hardware initialization failed, After plugging the DCT5100 into an electrical outlet to begin the boot cycle, Replace DCT5100

Eb 07 Object failed validation After software object download complete and FP is displayed, After a successful software object download and DCT5100 is reset, Contact headend operator

OR No action required because DCT5100 repeats software object download process

A few added from the DVi5000

Eb 08 Corrupt NVM Detected, After pluggin in the DCT into an electrical outlet to begin the boot cycle, Replace

Eb 09 Sanity Check Failure, Reset witin two minutes of a complete software object download, no action becaus the DCT repeats the download process