- New PVC frame design for GH10
- Diode bridges as RF switches
- Driving element is slightly shorter than half wavelength
- Element Bend Offset Modeling
- GH antenna appropriate for me?
- Current Versions of 4221 and DB4 for Channels 14-20
- Which GH design to use for attic?
- Small Yagi for 174-216 MHz
- Beginner LPDA VHF antenna question
- Narrowband GH6 poor performance
- Salvage old antenna or rebuild?
- Best Antenna to build for North Toronto?
- A linear (gapless) reflector design.
- SBGH or DBGH
- Building a DIY TV signal amplifier
- Which one should I build?
- SBGH-10 Gold Standard is done and on the roof
- Can portable DVB-T antenna be modded for ATSC?
- Wide-Band Gray-Hoverman construction help?
- What's wrong with my DIY antenna?
- Buy CM4221 vs. Build mclapp 4-Bay?
- Can I get two DTV VHF-Hi channels @ -14 dB?
- Arlington, WA: I'm full of questions.
- Drawings for ota antennas
- Best indoor antenna configuration for this TVFool?
- Help, my GH build performs worse than ZSS
- Calculate optimum bowtie dimensions?
- CM4221HD: Bypassing the Built in Balun to a CM0264 Amp
- Which DIY Antenna for Kleinburg, ON?
- First build of Gold Standard GH
- 4 bay reflector size
- Multiple rabbit ear kludge?
- My first SBGH, and problems!
- Dual Gapless Antenna
- Digital signals lost late at night
- 90º Bends on 1/4" 6061T6 Al. Element Zigzags
- Best way to mount two Wade 10y13 VHFs side by side?
- which antenna for wi-fi?
- YagiMax Software Tool
- Is the commercial 10y13s an optimized design?
- Model help for UHF pan antenna
- Questions about Inconsistent GH Results
- Double-sided GH6?
- Question on open 300ohm ladder wire
- how do you read the polar curve of antenna radiation pattern?
- Question about odd multiples of quarter wavelength
- Pittsburgh, Pa - trouble with mclapp antenna
- 3-Bay Bowtie?
- Tilt VHF element forward for higher gain?
- How to decide which model to build?