Heh, well the stubs are really bent up too.
but are separated by blue plastic insulators which allow you to fold the antenna up.
Yup, I have a few questions, heh. If possible, unless noted, please use center of wire/rod to center of wire/rod measurements. Measure with the antenna in operational position.
When the reflectors are folded in their operational position, what is the air gap distance between the reflector rods ?
What is the distance between the reflector rods and the elements ?
What are the vertical distances between all the reflectors? Starting at the top and working down would be good. A cummulative measurement would be fine.
What are the total lengths of each reflector rod pair tip to tip, assuming they were all there and including the gap ? Starting at the top and working down in the same corresponding order as the above vertical distances.
What is the horizontal distance between > < gaps. Is it the same for all the > < gaps ?
What is the vertical distances between > < gaps. Is it the same for all the > < gaps ? Starting at the top and working down would be good.
On an unbent horizontal stub, what is the length ? Are all the stubs the same ?
What is the length of a leg ? A leg defined as a section of the diamond. Are they all the same ? Or are the top and bottom bay leg lengths different ?
It looks like all the diamonds form 90 degree corner bends. Is that correct ?
What is the horizontal distance between the phasing lines ?
What is the distance from the feed point of the top single bay to the bottom single bay ? In other words, the length of the phasing line.
How far in front of the elements is the phasing line ?
Are the phasing lines 3/8 inches too ? If not, what gauge wire ?