Having some problems with our Sharp Aquos LC60LE632U 60" LED TV.
Here is the setup
Cable from wall > Rogers HD Box IN
HDMI from Rogers HD Box > Back of TV HDMI 1 input
worked fine for first few weeks, now all of a sudden when we turn on our TV we usually get the message "No Input Signal Available". The remote control then doesn't work, we can't change the input or anything on remote. Meanwhile, the cable is still on, but that message appears over it. We have to shut the tv off then turn on again and hope it went away.
And the only way to shut tv power off is by the controls on side of tv. When we hit menu or input on side of tv, they don't do anything as well, just power works.
As if that wasn't enough, now it sometimes pops up the menu automatically and starts scrolling through all the menu options, repeatedly... just goes crazy by itself.
I did a software update... downloaded latest version and installed, still does all this.
I contacted Sharp Canada and here's what they said
So I'm thinking maybe it's looking for cable, so I hooked up cable out from rogers box to cable in to tv.... did a channel search in the menu, it found the channels, so when on TV input there is channels, and then I just switch it to HDMI 1 input and get the HD TV. Well that only worked for a few hours, as soon as I shut tv off and turned on again the No Input Signal Available message appeared again. Then sometimes when I turn tv on it goes straight to TV Input (Not HDMI 1) and starts scrolling by itself through all the channels, crazy! I then removed the TV input setting so doesnt show up or go to that input, but same thing.
Anyone have this "No Input Signal Available" message and have a fix for it??? I think my TV is just gone nuts and returning it back to the store to replace..... I give up.
Here is the setup
Cable from wall > Rogers HD Box IN
HDMI from Rogers HD Box > Back of TV HDMI 1 input
worked fine for first few weeks, now all of a sudden when we turn on our TV we usually get the message "No Input Signal Available". The remote control then doesn't work, we can't change the input or anything on remote. Meanwhile, the cable is still on, but that message appears over it. We have to shut the tv off then turn on again and hope it went away.
And the only way to shut tv power off is by the controls on side of tv. When we hit menu or input on side of tv, they don't do anything as well, just power works.
As if that wasn't enough, now it sometimes pops up the menu automatically and starts scrolling through all the menu options, repeatedly... just goes crazy by itself.
I did a software update... downloaded latest version and installed, still does all this.
I contacted Sharp Canada and here's what they said
of course I did all that, I even removed the HDMI and hooked it up via Component Cables. Seemed ok at first, then 2nd day or so started doing same thing, No Input Selection Available.
So I'm thinking maybe it's looking for cable, so I hooked up cable out from rogers box to cable in to tv.... did a channel search in the menu, it found the channels, so when on TV input there is channels, and then I just switch it to HDMI 1 input and get the HD TV. Well that only worked for a few hours, as soon as I shut tv off and turned on again the No Input Signal Available message appeared again. Then sometimes when I turn tv on it goes straight to TV Input (Not HDMI 1) and starts scrolling by itself through all the channels, crazy! I then removed the TV input setting so doesnt show up or go to that input, but same thing.
Anyone have this "No Input Signal Available" message and have a fix for it??? I think my TV is just gone nuts and returning it back to the store to replace..... I give up.